American access system ADV-1000 Guide de l'utilisateur télécharger pdf (Page 336)

336 WIN-PAK User Guide

4 Select the Firmware Version being used in the

panel.

This refers to the version of firmware of the

PROM chip in your NS2+ panel. The default is

1.0 or later. If your panel has a different

firmware version, enter the number here.

5 Indicate the Status of the panel.

Active is used when a panel is configured and

present.

Inactive should be used for a panel that is

present but temporarily disconnected for mainte-

nance.

Not Present allows a system to be defined before

the physical installation is complete.

Card additions or deletions sent to an Inactive

panel are saved until the panel is made active. If

the panel is marked Not Present, no transactions

are saved.

6 Enter the panel's hardware Address. This

address corresponds to the DIP Switch setting on

the control panel and falls within the range of 1

to 31. Consult the NS2+ Installation Manual for

details.

7 Create an ADV for the panel, by clicking the

Add button in the ADV section (upper right

corner) of the configuration window.

8 On returning to the Panel Configuration - Basic

window [after creating the ADV], click the Next

button to advance to the Panel Configuration -

Card Format window (next illustration).

1 2 ... 331 332 333 334 335 336 337 338 339 340 341 ... 776 777

Commentaires sur ces manuels

Pas de commentaire